An experiment to determine the unknown resistance of a resistor using a wheatstone bridge

The instruments are in approximate chronological order: McKay, President of the company. In wooden box stamped Original Transatlantic Cable.

An experiment to determine the unknown resistance of a resistor using a wheatstone bridge

R2 and R4 are known resistors. Balanced or null condition when there is no voltage difference or flow of current in between the midpoints of the two edges is necessary to find the value of unknown resistance through wheatstone bridge.

An experiment to determine the unknown resistance of a resistor using a wheatstone bridge

Applications of Wheatstone bridge The circuit has many application, you might have been using a device which have been using the setup.

Measuring Strain with the help of Wheatstone bridge The Wheatstone Bridge circuit is used to measure the strain. In order to measure the strain, The strain gauges are used in the place of variable resistance.

The electrical resistance of the strain gauges varies with the increase or decrease in the strain of the device. So, In order to measure strain the wheatstone bridge circuit is used.

The setup is very helpfull when it comes to measure the fraction of changes in resistance with high accuracy. The resistance or LDR does varies as the intensity of light varies, With the help of potentiometer we can define that at how much intensity of light there will be the balance point.

There are other bonus conditions as well such as before and after what amount of light the current flows in a positive as well as negative direction from one edge to another. Other Applications of Wheatstone bridge The circuit is used in the light detecting devices.

For measuring the changes in the pressure. For measuring the changes in the strain of the circuit. They are also used for sensing mechanical and electrical quantities. These circuits can also be used in devices like photoresistive devices. Wheatstone bridges are also used in the thermometers for the temperature measurements which need to be accurate.80 CIVIL WAR ERA PHELPS CAMELBACK KOB, Marked caninariojana.com-MAKER.:(27KB) These Phelps Camelback keys were the most widely used of the Civil War keys.

Wheatstone Bridge - MagLab

Camelback keys have an upward lump like a camel's hump on the lever between the knob and the pivot. In order to determine the resistance of the unknown resistor, the resistances Determine the value of an unknown resistance using the Wheatstone bridge. unknown resistance of resistor No.

1 and let R (Rk/R3) be the standard resistance. For this experiment a Wheatstone bridge circuit was constructed from component parts and used to determine the resistance of 5 different lengths of conductive wire.

Measurements were made for each of the five coils and the resistance calculated analytically.1/5(1). For an unbalanced Wheatstone Bridge, you can use something called the voltage node method.

3 thoughts on “Meter Bridge Experiment using Wheatstone Bridge Principle”

This relies on your knowledge of Kirchoff's Current Law - the fact that the sum of all currents flowing into and out of a node is zero. The Wheatstone bridge is a circuit used to compare an unknown resistance with a known resistance. A schematic is shown below: The unknown resistor is R x, the resistor R k is known, and the two resistors R 1 and R 2 have a known ratio, although their individual values may not be known.

An experiment to determine the unknown resistance of a resistor using a wheatstone bridge

EXPERIMENT 10 THE WHEATSTONE BRIDGE I. THEORY The Wheatstone Bridge is an instrument designed for measuring an unknown resistance by comparing it with a known, or standard, resistor.

In the schematic diagram in section IV.

Experiment using a Wheatstone Bridge | Physics Forums